Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual page 83

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
Enable the 'Authentication Failure' trap [no]:
Step 15
Enable the SCE enterprise traps []:
Step 16
Note that there is no default for this parameter.
Enter system administrator contact name []:
E
XAMPLE
Following is a sample SNMP configuration, configuring one trap manager, one GET community,
and one SET community, and enabling the authentication failure trap, as well as all enterprise
traps.
Would you like to enter the SNMP configuration menu? [no]: y
Enable SNMP management? [no]: y
Enter SNMP GET community name[]: public
Enter Access list number allowing access with this community string, use '0'
to allow all: 0
Would you like to add another SNMP GET community? [no]:
Enter SNMP SET community name[]: private
Enter Access list number allowing access with this community string, use '0'
to allow all: 2
Would you like to add another SNMP SET community? [no]:
Would you like to configure SNMP trap managers? [no]: y
Enter SNMP trap manager IP address: 10.1.1.253
Enter SNMP trap manager community string: public
Enter trap manager SNMP version: 2c
Would you like to add another SNMP trap manager? [no]:
Enable the 'Authentication Failure' trap [no]: y
Enable SCE enterprise traps []: y
Enter system administrator contact name []: John Smith
OL-7824-02
To disable the Authentication Failure trap, press Enter.
•
To enable the Authentication Failure trap, type y and press Enter.
•
Configure the SCE enterprise trap status.
To disable the SCE enterprise traps, type n press Enter.
•
To enable the SCE enterprise traps, type y and press Enter.
•
Type the name of the system administrator and press Enter.
:
SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-19