Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual page 46

Installing the SCE 2000 Platform
To install the crossrail supports on a four-post rack (both front and back posts), complete the
following steps:
Step 1
Make sure that they are oriented so that both crossrails will support the SCE 2000 when they are attached to
the rack.
Figure 4-6: Assembling the Slider Brackets
Step 2
Step 3
SCE 2000 4xGBE Installation and Configuration Guide
4-10
Assemble the two crossrail supports as illustrated below. Use three screws for each
crossrail assembly.
Align the crossrail supports with the side of the rack, parallel to the floor.
Insert and tighten two screws to the front posts or mounting strips of the rack
Chapter 4 Installation and Maintenance
OL-7824-02