Setting Up The Local Console - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Connecting the Local Console

Setting Up the Local Console

This section provides instructions for setting up your local terminal at your workstation, to enable
you to perform the initial system configuration of the SCE 2000 system using the setup utility.
Figure 5-1: Connecting to the Local Console
Make sure that the terminal configuration is as follows:
•
•
•
•
•
The above SCE 2000 port parameters are fixed and are not configurable.
To set up the local console, complete the following steps:
Step 1
Make sure that you push on the RJ-45 connector (attached to the RS-232 serial cable) until you hear a
"click", which indicates that the connector is fully inserted and secured in the receptacle. Gently pull on the
plug to confirm whether the plug is locked into the socket.
Step 2
Step 3
SCE 2000 4xGBE Installation and Configuration Guide
5-2
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
9600 baud
8 data bits
No Parity
1 stop bits
No flow control
Plug the RS-232 serial cable provided with the SCE 2000 into the CON port on the front
panel of the SCE 2000.
Connect the other end of the serial cable (with an attached DB-9 connector) to the
VT100 compatible local (serial) terminal.
Make sure the local terminal is configured as a VT-100 terminal, according to the fixed
SCE 2000 CON port parameters.
OL-7824-02