Power Supply Specifications - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Power Supply Overview
Table 4-5
LED State
On (green)
Off
Table 4-6
Units
LED State
Continuous green
Red
Unlit
Simple Network Management Protocol (SNMP) monitors the activity of the power supplies. In most
Note
cases when a power supply problem occurs, an SNMP trap is sent in SNMP and the appropriate
message is posted on the SCE 2000 CLI.

Power Supply Specifications

The following table lists the AC-input and DC-input power supply specifications for the SCE
2000 platform:
Table 4-7
AC-input power
AC-input voltage rating
AC-input current rating
AC-input frequency rating
AC-input cable
DC-input power
DC-input voltage rating
DC-input current rating
DC-input cable
DC-input circuit breaker
SCE 2000 4xGBE Installation and Configuration Guide
4-18
OK LED Status for AC-input and DC-input Power Supply Units
Power Supply Unit Condition
The output voltage is in the required range (between 11.9 and 12.1 VDC).
The output voltage is not within the required range. (is greater than 12.1
VDC or less than 11.9 VDC)
Power LED (on front panel) Status for AC-input and DC-input Power Supply
Power Supply Unit Condiiton
Corresponding power supply unit is present and functioning normally
Corresponding power supply unit present, but malfunctioning
Corresponding power supply unit is either not present or has failed.
SCE 2000 Power Supply Specifications
200W maximum
100 to 240 VAC
Rated for 4.5A when Vin = 100 VAC or 2A when Vin = 200 VAC
50 to 60 Hz
18 AWG three-wire cable, with a three-lead IEC-320 receptacle on
the power supply end, and a country-dependent plug on the power
source end.
200W maximum
–48/-60 VDC nominal (–36 to–72 VDC supply tolerance)
7A at –48 VDC
12 AWG or 2.5-mm copper installation wire with hex or loop
connectors
One Fast 10A for each power supply unit
Chapter 4 Installation and Maintenance
OL-7824-02