Connecting The Management Interface - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Connecting the Management Interface

E
XAMPLE
Following is an example of a configuration that was applied and saved to the startup configuration
as well as to an FTP site.
Although not demonstrated in this example, it is recommended that you always view the
configuration before applying it.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]:
Apply and Save this configuration? [yes/no]: y
(New configuration would be displayed here)
The running configuration would be overwritten by the changes you have just
entered, are you sure? [yes/no]:y
The new running configuration will be saved to the startup configuration.
Do you want to save a copy of the startup configuration file in a remote
station? [no]:y
Enter a full FTP path of the remote destination:
ftp://vk:vk@10.1.1.253/h:/copyofstartup.txt
Committing configuration...
Configuration completed successfully.
Saving configuration...
Writing general configuration file to temporary location...
Backing-up general configuration file...
Copy temporary file to final location...
Done!
E
XAMPLE
Following is an example of a configuration that was aborted, although no errors were detected.
Data collection for the system configuration is completed.
Would you like to view the new configuration before it is applied? [yes/no]:
Apply and Save this configuration? [yes/no]: n
The changes you have just entered would be discarded, are you sure?
[yes/no]:y
Setup procedure aborted, no configuration changes made.
Connecting the Management Interface
The procedures for cabling the management port and testing connectivity between the SCE 2000
and the remote management host are explained in the following sections:
•
•
Note By default, the management port is configured to auto-negotiation enabled. To change this default
setting, refer to Configuring the Management Interface Speed and Duplex Parameters.
SCE 2000 4xGBE Installation and Configuration Guide
5-26
Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
#2:
#3:
Cabling the Management Port (on page 5-27)
Verifying Management Interface Connectivity (on page 5-28)
OL-7824-02