Attaching The Crossrail Supports To The Rack - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Chapter 4 Installation and Maintenance
Figure 4-5: Attaching the Mounting Brackets (2-post)
Step 3
This completes the steps for attaching the rack-mount brackets to the SCE 2000.
If mounting the SCE 2000 in a rack with only two posts, skip to Mounting the System to a Rack (Mounting
the System to a Rack
If mounting the SCE 2000 in a rack with four posts, proceed to the next step to attach the crossrail supports
to the rack.

Attaching the Crossrail Supports to the Rack

When mounting in a rack with four posts (front and back) the two crossrail supports are mounted
one on each side of the rack. The SCE 2000 then slides into these crossrails, which support the
weight of the unit.
Cisco recommends that you allow at least 1 or 2 inches (2.54 or 5.08 cm) of vertical clearance between
Note
the SCE 2000 and any equipment directly above and below it.
OL-7824-02
Repeat steps 1 and 2 on the other side of the SCE 2000.
"Mounting the System to the Rack" on page 4-11).
SCE 2000 4xGBE Installation and Configuration Guide
Installing the SCE 2000 Platform
4-9