Monitoring The System - Cisco CE 2000 Platform SCE 2000 4xGBE Installation And Configuration Manual

Cisco systems ce 2000 platform installation and configuration guide
Hide thumbs Also See for CE 2000 Platform SCE 2000 4xGBE:
Table of Contents

Advertisement

Chapter 6
Cabling the Line Ports and Completing the Installation
Sniffing: allows the SCE 2000 platform to forward traffic on the specified link through the
bypass mechanism while still analyzing the traffic passively.
Sniffing is permitted to be configured for for all links, only (use the all-links option).
Cutoff: completely cuts off flow of traffic through the specified link.
Note the following recommendations and restrictions:
Since the SCE 1000 platform has only one link, the link is not specified.
Since the SCE 2000 platforms have more than one link, it is required to specify the link. The
link designations are different for the GBE and FE platforms, as follows:
Use the 'all-links' option to configure the link mode for all links (SCE 2000 platforms
only).
It is recommended that both links be configured together. Use the all-links option.
Link mode is relevant only to inline topologies.
It is recommended that in cascaded topologies, both SCE 2000 platforms be configured for
the same link mode, otherwise the service will be unpredictable.
Sniffing can only be configured for all links, therefore, to configure sniffing, the all-links
option is required, not just recommended.
The default link mode is forwarding. When other link modes are selected, active service
control is not available and any service control configuration will not be applicable.
To set the link mode:
Step 1

Monitoring the System

Use the following commands to view the current connection mode and link mode parameters.
To view the current connection mode:
Step 1
OL-7824-02
SCE 2000 4xGBE: GBE1-GBE2/GBE3-GBE4
SCE 2000 4/8xFE: LINK1/LINK2
From the SCE 2000 (config if)# prompt, type link-mode [<link>|all-
links] [forwarding|bypass|sniffing|cutoff] and press Enter.
#
From the SCE 2000
connection-mode and press
prompt, type show interface linecard 0
Enter
.
SCE 2000 4xGBE Installation and Configuration Guide
Installing a Cascaded System
6-15

Advertisement

Table of Contents
loading

Table of Contents