Chapter 5 Connecting The Management Interfaces And Performing Initial System Configuration; How To Set Up The Local Console - Cisco SFE2000P Installation And Configuration Manual

Connecting the Management Interfaces and
Performing Initial System Configuration
This chapter explains how to connect the SCE 2000 platform to a local console and perform the initial
system configuration via the setup wizard that runs automatically.
Additionally, this chapter contains instructions for cabling the Fast Ethernet Management interfaces.
Note When installing a cascaded system, it is extremely important to follow the sequence of procedures
outlined.
•
•
•

How to Set Up the Local Console

Even if you will be managing the SCE 2000 from a remote location, you must first connect the unit to a
local console and configure the initial settings for the SCE 2000 to support remote management. When
the initial connection is established, the setup utility will run automatically, prompting you to perform
the initial system configuration.
This section provides instructions for setting up your local terminal at your workstation, to enable you
to perform the initial system configuration of the SCE 2000 system using the setup utility.
Figure 5-1
1 2
OL-7824-06
How to Set Up the Local Console
Initial System Configuration
Connecting the Management Interface
Connecting the Local Console to the SCE 2000 CON Port
PW R A
PW R B
STA TU S
BY PAS S
MN G 1
MN G 2
CO NS OL
E
AU X LIN K RX
LIN K/
10/1 00/ TX
ACT IVE
100 0 LIN K/
10/1 00/
ACT IVE
100 0
RX
MM
TX
GB E-1
SU B
LIN E
3
C H A P T E R
C is co S
C E 2 0 0 0
Se rie s
4 xG B E
LIN K RX
TX
LIN K RX
TX
LIN K RX
TX
RX
MM
TX
RX
MM
TX
RX
MM
TX
NE T
GB E-2
SU B LIN
E/C AS CA
DE NE T
Cisco SCE 2000 4xGBE Installation and Configuration Guide
5
5-1