Power Supply Power Cord Specifications - Cisco 8800 Series Hardware Installation Manual

Power Supply Power Cord Specifications

Step 5
Turn on the circuit breaker for the HVAC or HVDC power source circuit.
Note
What to do next
Use the power-mgmt redundancy-num-pms number command in config mode to convert the power module
redundancy from n+1 to n+x, specifying the number of redundant power modules that the you want to configure.
The total number of functioning power modules in the system is at least x number more than the number of
power modules that are needed to support the power required for all the cards in the system. The range is
0–11; 0 means that no power redundancy is required.
RP/0/RP0/CPU0:ios# config
RP/0/RP0/CPU0:ios(config)# power-mgmt redundancy-num-pms 2
RP/0/RP0/CPU0:ios(config)# commit
Tue Sep 24 09:03:22.889 UTC
Commit complete.
Use the hw-module attention-led location0/PM number command in config mode to enable and use the no
form of the command to disable the ID LED on the specified power supply.
RP/0/RP0/CPU0:ios# config
RP/0/RP0/CPU0:ios(config)# hw-module attention-led location 0/PT0-PM0
RP/0/RP0/CPU0:ios(config)# commit
RP/0/RP0/CPU0:ios(config)# end
RP/0/RP0/CPU0:ios# show led location 0/PT0-PM0
================================================================================
Location
================================================================================
0/PT0-PM0
Power Supply Power Cord Specifications
Note
Always use the Saf-D-Grid connector toward the router.
Hardware Installation Guide for Cisco 8800 Series Routers
56
If you use both inputs, the IN LED of the power supply is green. If you use only one input, the IN
LED is blinking green.
Led Name Mode
Attention OPERATIONAL
Fault OPERATIONAL
Input OPERATIONAL
Output OPERATIONAL
Color
BLINKING BLUE
OFF
GREEN
GREEN
Powering on the Router