Replacing The Projector Lamp-Part Number Cts-Prjtr-Bl-Gen1= Or Cts-Prjtr-Gen2-Ch (China) - Cisco 3000 Use & Care Manual

Replacing the Projector Lamp—Part Number CTS-PRJTR-BL-GEN1= or CTS-PRJTR-GEN2-CH (China)
Replacing the Projector Lamp—Part Number
CTS-PRJTR-BL-GEN1= or CTS-PRJTR-GEN2-CH (China)
A likely cause of a malfunctioning projector is a burnt-out projector lamp. The life of the light bulb is
approximately 2000 hours.
The Sanyo part number for the projector lamp is POA-LMP94 (all countries except China) or
Note
POA-LMP114 (China only).
Power off the projector by turning off the power switch on the back of the unit.
Step 1
Allow the project to cool down for at least 45 minutes, or wear heat-resistant gloves during the
Step 2
replacement process.
Unplug the HD Video cable, power cable, and serial cable from the rear of the unit.
Step 3
Remove the privacy panel.
Step 4
Note how the bracket attaches to the underside of the tabletop and perform one of the following actions:
Step 5
•
Note
•
Loosen the screw that secures the lamp cover, then open the lamp cover. Access the cover through the
Step 6
cut-out rectangle on the projector mounting bracket.
The lamp cover is located in one of the following places:
•
•
Use the screwdriver to loosen the two screws that secure the lamp fixture in place.
Step 7
Use the handles to remove the lamp module.
Step 8
Cisco TelePresence System 3000
11-24
If the bracket attaches to the tabletop using screws and keyhole slots in the projector bracket,
complete the following steps to remove it from the tabletop and continue to
Remove two of the six screws that hold the projector assembly to the underside of the center
a.
tabletop. These screws are the rear-most of the six screws and the furthest away from the
projector lens.
b. Loosen the remaining four mounting screws.
You might have to remove the screws and remove the assembly during this step, rather than
loosen the screws. Be sure to secure the projector when you remove the screws.
Remove the projector assembly by sliding the unit to the side until the projector mounting
c.
bracket disengages from the loosened mounting screws.
If the bracket attaches to the tabletop with screws that hold the bracket by its edges, complete the
following steps to remove it from the tabletop:
Loosen the six screws that attach the projector assembly to the tabletop.
a.
b. Remove the projector assembly by sliding the unit to the front until the projector mounting
bracket disengages from the loosened mounting screws.
On the underside of the projector. Since the projector is mounted upside-down, the cover is located
on the side that is nearest to the table top.
On the rear of the projector (China only)
Chapter 11 Field-Replaceable Unit Guide
Step 6:
OL-14521-01