Replacing a Plasma Display—Part Number CTS-DISP-65-GEN4=
Replacing a Plasma Display—Part Number
CTS-DISP-65-GEN4=
Required Information, Tools, and Equipment
To disassemble and reassemble portions of the Cisco TelePresence 3000 to replace a display, you need
the following information, tools, and equipment:
•
•
Uncrating and unpacking:
•
•
•
•
•
•
•
Cisco TelePresence 3000 Structure, Accessory, and Adjustment Assembly:
•
Tip
•
•
•
•
•
•
•
•
•
* Recommended for best results
Cisco TelePresence System 3000
11-6
Release Notes for Cisco TelePresence System, Release 1.4, OL-12074-05
Cisco TelePresence System Release 1.4 Administrator's Guide, OL-13676-03
Claw hammer or small pry bar
Large Phillips screwdriver
* Tin snips
* Pallet jack or hand cart (for moving components)
* Safety gloves
* Safety glasses
* Box cutters
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
A round-head Allen bit allows the bit to work at an angle instead of only straight out, which is
helpful in tight spots.
Manual screwdrivers, Phillips and flat head types
Metric wrenches, 10 to 15 mm
9/64-inch Allen wrench (supplied with speakers)
0.9mm Allen wrench for camera lens adjustments (if the lens uses a thumbscrew no tools are
required)
Level
Masking tape
* Tie wraps
Laptop computer attached to network
* Step ladder
Chapter 11
Field-Replaceable Unit Guide
OL-14521-01