Cisco 3000 Use & Care Manual page 151
Cisco systems network device assembly guide
Hide thumbs
Also See for 3000:
- Regulatory compliance and safety information manual (32 pages) ,
- Administration manual (496 pages) ,
- Configuration handbook (359 pages)
Table of Contents
Advertisement
Chapter 8
Routing Power and Signal Cables
Step 12
Connect the camera assembly cables.
Figure 8-12
Cabling the Camera assembly
5
RJ45 Power over Ethernet
10
HDMI connector
The camera cluster can experience radio frequency interference issues if the camera Ethernet and video
Note
cables are routed, bundled, or tied together. Cisco recommends that you route the Ethernet and video
cables separately and use cable ties to tie them to opposite sides of the frame.
Figure 8-12
Tip
Before you plug cables into a Codec, label each cable.
OL-14521-01
displays the rear view of the Cisco TelePresence System 3000. Left and right are reversed.
Power Requirements for the Cisco TelePresence 3000
Cisco TelePresence System 3000
8-15
Advertisement
Chapters
Table of Contents
