Cisco 3000 Use & Care Manual page 105

Chapter 6 Building the Table Assembly
Step 10 Attach the left Table segment.
a.
b.
c.
d.
The splines have different lengths. Use a spline that is slightly smaller than the slot in the table top.
Note
Figure 6-23 Left Table segment
OL-14521-01
The draw bolts have two halves that screw into a center piece.
While a draw bolt is being tightened, hold the table edges together to avoid damage to the draw bolt
or the table segment.
Tighten the draw bolts so the two table segments are connected snugly.
While one person is tightening the draw bolts from below, it is important for the support person to
maintain the alignment of the table segment edges.
7
12
10
Building the Table Assembly, Product ID CTS3K-M-TABLE-G2
6
Cisco TelePresence System 3000
6-27