Table of Contents
Advertisement
Chapter 17
Field-Replaceable Unit Guide
Replacing a Codec—Part Number CTS-CODEC-PRI-G2R= or
CTS-CODEC-PRI-RCH= (PRC)
This procedure describes the steps you perform to remove and replace a TX9000 or TX9200 codec and
includes the following topics:
•
•
•
Required Tools
A #2 Phillips head screwdriver is required.
Removing and Replacing the Codec
To remove and replace a codec, complete the following steps:
Step 1
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
to the "OFF" position.
Remove the cables from the codec.
Step 2
See
Step 3
Remove the codec by completing the following steps:
a.
b.
c.
Step 4
Install the new codec into the cabinet by completing the following steps:
a.
b.
c.
d.
Complete the following steps to configure the new codec in Cisco Unified Communications Manager:
Step 5
a.
b.
c.
d.
OL-27038-01
Required Tools, page 17-15
Removing and Replacing the Codec, page 17-15
Upgrading CTS Software on a Secondary Codec, page 17-16
Figure 10-16
for a cable routing diagram.
Loosen, but do not remove, the four screws (two upper, two lower) that mount the codec to the
structure.
See
Figure 8-4
for more information.
Remove the codec assembly from the frame.
Remove codec brackets by removing the four captive screws (two top, two bottom) connecting the
codec brackets to the codec.
See
Figure 8-3
for more information.
Attach the codec brackets to the codec, using the captive screws on the brackets.
Install the codec onto the structure using the keyhole slots and tighten the four screws (two upper,
two lower).
Reconnect all cables to the replacement codec.
Close the bottom facade panels.
Open a browser on a computer connected to the network.
Access the Cisco Unified Communications Manager interface.
Add the Room Email ID of the previous codec to the new codec.
Make sure the new codec's status is registered.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Replacing a Codec—Part Number CTS-CODEC-PRI-G2R= or CTS-CODEC-PRI-RCH= (PRC)
17-15
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
