Cisco 3000 Use & Care Manual page 180

Cisco systems network device assembly guide
Table of Contents

Advertisement

Setting Up CTS Components
Changing these settings allows a projector to be monitored by SNMP when the projector is in an inactive
Note
state. If a projector lamp fails, SNMP does not properly report the failure from an inactive projector until
you complete these steps.
Use the projector remote control or press the buttons on the projector to complete these steps.
Tip
If your system uses a Sanyo PLV-Z700 projector, skip this step.
Note
Press the Menu key for 20 seconds.
a.
The letter S displays in the upper left corner of the screen.
Press the Screen key for 3 seconds.
b.
The service menu displays.
c.
Press OK until the group number setting changes to 100.
d.
Press the Down Arrow key until the No. setting changes to 4.
e.
Press the Left Arrow key until the Data setting changes to 0.
Press the ON-OFF key to end the service menu.
f.
Center the projector display within the screen by completing the following steps:
Step 6
Locate the lock switch and two dials on the side of the projector.
a.
Move the switch to the unlock position.
b.
Rotate the vertical dial to position the top of the image 1 inch below the bottom of the wood surface.
c.
Rotate the horizontal dial to position the sides of the image 15 inches from each of the seams on the
d.
table segments.
Completing this step should center the image in the screen. If the image is not centered, adjust the
image until the distance is equal from each table segment seam.
Move the switch to the lock position.
e.
Aim the remote control at the lens of the projector.
Step 7
You can use the screen to reflect the signal back to the projector if you are sitting at the table.
Tip
Leave the projector in this state. When the video signal is turned off or disconnected, the projector will
go black for 30 seconds. Then it will count down for 5 minutes and then turn off the lamp.
If a video signal is applied during this 5 minute and 30 second countdown the video will reappear
immediately. If the countdown completes, the projector goes into a cooldown mode which will ignore a
video signal for 30 seconds. It will then stay in a standby mode and will power back up when a video
signal is connected. It will take 15 seconds for the projector to light back up.
To check either VGA or document camera input, perform the following steps:
Step 8
Click Presentation Devices on the Hardware Setup window.
a.
Perform one of the following steps to test the video input:
b.
Cisco TelePresence System 3000
9-20
Chapter 9
First-Time Setup
OL-14521-01

Advertisement

Table of Contents
loading

This manual is also suitable for:

Telepresence 3000

Table of Contents