Cisco 3000 Use & Care Manual page 219

Chapter 11 Field-Replaceable Unit Guide
Step 8 Remove the draw bolts or cam locks between the table top sections on the side that you moved. See
Chapter 6, "Building the Table Assembly"
Step 9 If required, reposition the table leg so that it fully supports both table sections.
Move the table leg on the other side of the table top to allow access to the draw bolts or cam locks,
Step 10
making sure that the leg still supports both table top sections.
Step 11 Remove the draw bolts or cam locks between the table top sections on the side that you moved.
Step 12 Separate the table top sections to create a space between the section to be replaced of approximately one
inch (2.5 centimeters); this step allows you to remove the splines between the table top sections.
Move the sections to the left and use the space created by the open table door.
Tip
Be sure that the legs support all table top sections and do not allow any of the sections to fall.
Caution
Remove the splines from the slot in the edges of the table top section.
Step 13
Remove the table top section from the table legs.
Step 14
Place the new table top section on the table legs.
Step 15
Place the splines in the slots on the edge of the new table top section.
Step 16
Press the table top sections together.
Step 17
Insert the draw bolts or cam locks and tighten them between the new table top section and the adjoining
Step 18
table top sections. See
cam locks.
Attach the legs to the table top sections with the screws. See
Step 19
for the location of the table legs and screw attachment locations.
Reconnect the microphone to the new table top section.
Step 20
Either route the microphone cable to the codec or audio/video extension unit and connect the cable to
Step 21
the unit, or connect the microphone to the microphone extension cord.
See Figure 6-26
Close the table door.
Step 22
If you removed the table door, replace the door.
Step 23
See Figure 6-11
OL-14521-01
Chapter 6, "Building the Table Assembly"
for microphone installation instructions.
for table door installation instructions.
for the location of the draw bolts or cam locks.
for the location of the draw bolts or
Chapter 6, "Building the Table Assembly"
Cisco TelePresence System 3000
Replacing a Table Top Section
11-31