Cisco 3000 Use & Care Manual page 205

Chapter 11 Field-Replaceable Unit Guide
See Chapter 7, "Assembling the Remaining Cisco TelePresence Elements"
Remove the codec from the Display structure.
Step 5
Remove the L brackets from the codec.
Step 6
See Chapter 7, "Assembling the Remaining Cisco TelePresence Elements"
Remove the cable management bar from the codec. Retain the bar and the screws.
Step 7
See Chapter 7, "Assembling the Remaining Cisco TelePresence Elements"
Attach the L-brackets and Cable management bar to the replacement codec.
Step 8
See Chapter 7, "Assembling the Remaining Cisco TelePresence Elements"
Attach the codec to the display structure front feet using the screws that you removed in
Step 9
Turn the codec power switch to the On position.
Step 10
Caution
Reattach the cables according to your temporary masking tape identification.
Step 11
See Chapter 8, "Routing Power and Signal
Attach the cables to the cable management bar using tie wraps.
Step 12
If the replacement unit was the Primary codec, follow these steps.
Step 13
a. Open a browser on a computer connected to the network.
Access the Cisco Unified Communications Manager interface.
b.
c. Change the MAC address for the Primary codec to its new address.
Power on the system by turning the power switches to the On position on the two left PDUs, single right
Step 14
PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.
Step 15 In the browser on the computer, type in the IP address of the primary codec unit.
Step 16 Enter the required information at the login screen. The Cisco TelePresence Administrator window
appears.
Step 17 Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is Enabled/Up.
Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working
Step 18
properly.
Perform the Auto Adjust camera setup procedure. This sets the white balance to the correct levels. See
Step 19
the "Setting Up the Cameras" section on page 9-7
Note If you are replacing the primary codec, power it on and complete all steps before powering on the
secondary codecs. This prevents the secondary codecs from being affected by any software and
peripheral upgrades to the primary codec.
OL-14521-01
Replacing a Codec Unit—Part Number CTS-CODEC-PRI-G2= (Primary Codec) or CTS-CODEC-SEC= (Secondary
Make sure each PDU power switch is still in the Off position.
Cables", for additional information.
for detailed instructions.
Cisco TelePresence System 3000
for additional information.
for additional information.
for additional information.
for additional information.
Step 4.
11-17