Setting Up The Cameras; Starting The Software Setup - Cisco 3000 Use & Care Manual

Chapter 9 First-Time Setup

Setting Up the Cameras

The cameras are set up correctly when images are centered and in focus on the display screens and the
white balance has been configured. The hardware setup software provides a camera Auto Adjust feature
and a way to use targets to fine-tune the camera's focus.
This section describes the procedures you make to set up the camera and includes the following topics:
•
•
•
•

Starting the Software Setup

To start the software setup, complete the following steps.
Assemble the Large Camera Target.
Step 1
When you slide the Camera target into the frame, make sure the target is centered in the frame between
the vertical lines at the top and bottom of the target.
OL-14521-01
"Starting the Software Setup" section on page 9-7
"Adjusting the Zoom" section on page 9-9
"Focusing the Camera" section on page 9-13
"Attaching the Camera Hood Assembly" section on page 9-14
Setting Up CTS Components
Cisco TelePresence System 3000
9-7