Replacing the Camera Cluster—Part Number CTS3K-CAM-CLST-G2=
Table 11-1
List of FIeld-Replaceable Units for the Cisco TelePresence System (continued)
FRU Part Number
CTS-PRJTR-JC-GEN1=
CTS-PWR-PDU=
Replacing the Camera Cluster—Part Number
CTS3K-CAM-CLST-G2=
Required Information, Tools, and Equipment
To remove and replace the camera cluster for the Cisco TelePresence 3000, you need the following
information, tools, and equipment:
•
•
•
•
•
•
•
•
Powering Off the System
Power off the system by turning the power switches to the Off position on the two left PDUs, single right
PDU and, if present, the PDU or auxiliary control unit behind the center display assembly.
Make sure all system power is turned off before beginning this disassembly.
Caution
Removing the Camera Cluster
Make sure to retain all screws, brackets, and other parts during the disassembly.
Note
Take care not to scratch or mar the display screen during the replacement procedure.
Caution
Cisco TelePresence System 3000
11-4
Description
Jumper Cord From the projector
Power Distribution Unit for the Cisco TelePresence Systems
The
Cisco TelePresence System Administrator's Guide
The
Release Notes for Cisco TelePresence System
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
0.9mm Allen wrench for camera lens adjustments (if the lens uses a thumbscrew, no tools are
required)
Manual screwdrivers, Phillips and flat head types
Metric wrenches, 10 to 15 mm
Masking tape
Laptop computer attached to network
Chapter 11
Field-Replaceable Unit Guide
for your software release
for your software release
OL-14521-01