Replacing A Pdu-Part Number Cts-Pwr-Pdu - Cisco 3000 Use & Care Manual

Replacing a PDU—Part Number CTS-PWR-PDU=
Step 9 Reattach the assembly to the underside of the tabletop.
Reattach the VGA cable to the projector.
Step 10
Reattach the power cable to the projector.
Step 11
If your system uses an auxiliary control unit, reattach the serial cable to the auxiliary control unit.
Step 12
Perform the first-time setup procedure for the projector.
Step 13
See the
Follow the procedure that is specific to your system configuration. The procedure to follow depends on
Note
whether your system uses an auxiliary control unit.
Replacing a PDU—Part Number CTS-PWR-PDU=
There are two PDUs attached to the left accessory cabinet, one attached to the right accessory cabinet,
one PDU attached to the underside of the tabletop, and one attached to the center display structure.
Step 1 On the PDU to be replaced, turn the power switch to Off and remove the plug from the wall receptacle.
Remove any cables plugged into the PDU.
Step 2
Remove the PDU from the accessory cabinet or center Privacy panel by removing the mounting screws.
Step 3
Attach the replacement PDU.
Step 4
Plug in the jumper cords that were removed and turn the power switch to the On position.
Step 5
Plug the PDU power cord into the wall receptacle.
Step 6
Open a browser on a computer connected to the network.
Step 7
Type in the IP address of the center, primary codec unit. Enter the required information at the login
Step 8
screen. The Cisco TelePresence Administrator window appears.
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
Step 9
window) is Enabled/Up.
Choose System Restart to perform a software reset.
Step 10
Refer to the
information.
Cisco TelePresence System 3000
11-26
"Setting Up the Projector" section on page 9-19
Cisco TelePresence System Administrator's Guide
Chapter 11 Field-Replaceable Unit Guide
for more information.
for your software release for more
OL-14521-01