Cisco 3000 Use & Care Manual page 142

Power Requirements for the Cisco TelePresence 3000
Step 4 Route the power cables for the table leg foam bumper I/O modules and the projector.
Figure 8-4 Routing Power Cables for I/O Modules and Projector
8
9
The six jumper cords from the I/O modules in the table legs route to the center PDU.
Note
Before plugging the Table leg jumper cords into the Table PDU, label each one. For example, Outer Left
Tip
Power, Inner Right Power.
Cisco TelePresence System 3000
8-6
Table Leg Power
Projector Power
Chapter 8 Routing Power and Signal Cables
OL-14521-01