Makita SG150 Translation Of The Original Instruction Manual page 65

i) Wear personal protective equipment.
Depending on application, use face
shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing
protectors, gloves and shop apron capable
of stopping small abrasive or workpiece
fragments.
j) Keep bystanders a safe distance away from
work area. Anyone entering the work area
must wear personal protective equipment.
k) Hold the power tool by insulated gripping
surfaces only, when performing an
operation where the cutting accessory may
contact hidden wiring or its own cord.
l) Position the cord clear of the spinning
accessory.
m) Never lay the power tool down until the
accessory has come to a complete stop.
n) Do not run the power tool while carrying it at
your side.
o) Regularly clean the power tool's air vents.
p) Do not operate the power tool near
flammable materials.
q) Do not use accessories that require liquid
coolants.
2.6.2 Kickback and related warnings
a) Maintain a firm grip on the power tool and
position your body and arm to allow you to
resist kickback forces. Always use auxiliary
handle, if provided, for maximum control
over kickback or torque reaction during
start-up.
b) Never place your hand near the rotating
accessory.
c) Do not position your body in line with the
rotating wheel.
d) Use special care when working corners,
sharp edges, etc. Avoid bouncing and
snagging the accessory.
e) Do not attach a saw chain, woodcarving
blade, segmented diamond wheel with
a peripheral gap greater than 10 mm or
toothed saw blade.
f) Do not "jam" the wheel or apply excessive
pressure. Do not attempt to make an
excessive depth of cut.