Cisco ONS 15454 Procedure Manual page 51

Chapter 1 Install the Shelf and Backplane Cable
Metallic interfaces for connection to outside plant lines (such as T1/E1/T3/E3, etc.) must be connected
Warning
through a registered or approved device such as CSU/DSU or NT1.
Label all cables at each end of the connection to avoid confusion with cables that are similar in
Step 7
appearance.
Return to your originating procedure (NTP).
Step 8
DLP-A26 Install Coaxial Cable With High-Density BNC Connectors
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Place the cable connector over the desired connection point on the backplane.
Step 1
Using the BNC insertion tool, position the cable connector so that the slot in the connector is over the
Step 2
corresponding notch at the backplane connection point.
Gently push the connector down until the notch backplane connector slides into the slot on the cable
Step 3
connector.
Turn the cable connector clockwise to lock it into place.
Step 4
Tie wrap or lace the cables to the EIA according to Telcordia standards (GR-1275-CORE) or local site
Step 5
practice.
Route the cables to the nearest side of the shelf assembly through the side cutouts according to local site
Step 6
practice.
Metallic interfaces for connection to outside plant lines (such as T1/E1/T3/E3, etc.) must be connected
Warning
through a registered or approved device such as CSU/DSU or NT1.
The rubber-coated edges of the side cutouts prevent the cables from chafing.
Return to your originating procedure (NTP).
Step 7
March 2003
NTP-A9 Install the Electrical Card Cables on the Backplane
This task installs the coaxial cable with high-density BNC connectors.
BNC insertion tool
DLP-A12 Install a BNC or High-Density BNC EIA, page 1-17
Required if you are using DS3-12, DS3XM-6, or EC-1 cards and are using
a high-density BNC interface
Onsite
None
Cisco ONS 15454 Procedure Guide, R4.0
1-51