Cisco ONS 15454 Procedure Manual page 17

Chapter 1 Install the Shelf and Backplane Cable
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
EIAs are normally factory installed. Verify that the correct EIA is installed on the shelf assembly. If not,
Note
install the correct EIA.
Complete the
Step 1
are locking connectors; the high-density BNC also allows you to access every port on every card.
Complete the
Step 2
every port on every card using more space and efficient cabling.
Complete the
Step 3
exclusive to DS-1 cables.
Note
Continue with the
Step 4
Stop. You have completed this procedure.
DLP-A12 Install a BNC or High-Density BNC EIA
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Remove the BNC or high-density BNC card from the packaging. Line up the connectors on the card with
Step 1
the mating connectors on the backplane. Gently push the card until both sets of connectors fit together
snugly.
March 2003
"DLP-A12 Install a BNC or High-Density BNC EIA" task on page 1-17
"DLP-A13 Install an SMB EIA" task on page 1-19
"DLP-A14 Install the AMP Champ EIA" task on page 1-21
To attach cables to the EIAs, see the
Backplane" procedure on page
"NTP-A6 Install the Power and Ground" procedure on page
This task installs a BNC or high-density BNC EIA.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
Perimeter screws (9)
Inner screws (12)
Backplane cover screws (5)
BNC or high-density BNC card
NTP-A4 Remove the Backplane Covers, page 1-15
Required if you are using DS3-12, DS3XM-6, or EC-1 card and prefer a
BNC interface to an SMB interface
Onsite
None
NTP-A5 Install the Electrical Interface Assemblies
"NTP-A9 Install the Electrical Card Cables on the
1-45.
Cisco ONS 15454 Procedure Guide, R4.0
as needed. BNCs
as needed. SMBs allow you to access
as needed. AMP Champs are
1-23.
1-17