Cisco ONS 15454 Procedure Manual page 47

Hide thumbs Also See for ONS 15454:

Chapter 1

Install the Shelf and Backplane Cable

Figure 1-20 Backplane with an SMB EIA for DS-1 Cables

Return to your originating procedure (NTP).

Step 4

DLP-A24 Install DS-1 AMP Champ Cables on the AMP Champ EIA

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed

Onsite/Remote

Security Level

Step 1

Prepare a 56-wire cable for each DS1N-14 card you will install in the shelf assembly.

Step 2

Connect the male AMP Champ connector on the cable to the female AMP Champ connector on the

ONS 15454 backplane.

Step 3

Use the clips on the male AMP Champ connector to secure the connection.

The female connector has grooves on the outside edge for snapping the clips into place.

Table 1-7

EIA.

Note

Table

25 pairs of wires coded with an industry-standard color scheme.

March 2003

DS-1 Electrical Interface

Adapter or balun

This task installs the DS-1 AMP Champ cables on the AMP Champ EIA.

Wire wrapper

Twisted-pair cables

DLP-A14 Install the AMP Champ EIA, page 1-21

Required if you are using an AMP Champ EIA for DS1N-14 cards

Onsite

None

shows the pin assignments for the AMP Champ connectors on the ONS 15454 AMP Champ

1-7, the shaded area corresponds to the white/orange binder group. A binder group is a set of

NTP-A9 Install the Electrical Card Cables on the Backplane

Cisco ONS 15454 Procedure Guide, R4.0

1-47