Cisco ONS 15454 Procedure Manual page 12

NTP-A3 Open and Remove the Front Door
NTP-A3 Open and Remove the Front Door
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Complete the
Step 2
Continue with the
Step 3
Stop. You have completed this procedure.
DLP-A8 Open the Front Cabinet Compartment (Door)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The ONS 15454 has an ESD plug input and is shipped with an ESD wrist strap. The ESD plug input is
Note
located on the outside edge of the shelf assembly on the right-hand side. It is labeled "ESD" on the top
and bottom. Always wear an ESD wrist strap and connect the strap to the ESD plug when working on
the ONS 15454.
Open the front door lock
Step 1
The ONS 15454 comes with a pinned hex key for locking and unlocking the front door. Turn the key
counterclockwise to unlock the door and clockwise to lock it.
Press the door button to release the latch.
Step 2
Swing the door open.
Step 3
Cisco ONS 15454 Procedure Guide, R4.0
1-12
This procedure describes how to open and remove the front door to access
the equipment.
Open-end wrench
Pinned hex key
NTP-A2 Install the Shelf Assembly, page 1-5
Required
Onsite
None
"DLP-A8 Open the Front Cabinet Compartment (Door)" task on page
"DLP-A9 Remove the Front Door" task on page
"NTP-A4 Remove the Backplane Covers" procedure on page
This task describes how to open the front cabinet compartment door.
Pinned hex key
NTP-A2 Install the Shelf Assembly, page 1-5
Required
Onsite
None
(Figure 1-3 on page
Chapter 1 Install the Shelf and Backplane Cable
1-13.
1-13).
1-12.
1-15.
March 2003