Cisco ONS 15454 Procedure Manual page 15

Chapter 1 Install the Shelf and Backplane Cable
NTP-A4 Remove the Backplane Covers
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Complete the
Step 2
If you plan to install electrical interface assemblies (EIAs), continue with the
Step 3
Electrical Interface Assemblies" procedure on page
Power and Ground" procedure on page
Stop. You have completed this procedure.
DLP-A10 Remove the Lower Backplane Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Unscrew the five retaining screws that hold the clear plastic cover in place.
Step 2 Grasp the clear plastic cover on each side.
Gently pull the cover away from the backplane.
Step 3
Return to your originating procedure (NTP).
Step 4
March 2003
This procedure describes how to access the backplane by removing the
covers. The backplane has two sheet metal covers (one on either side) and
a lower backplane cover at the bottom.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-A2 Install the Shelf Assembly, page 1-5
Required
Onsite
None
"DLP-A10 Remove the Lower Backplane Cover" task on page
"DLP-A11 Remove the Backplane Sheet Metal Cover" task on page
1-23.
This task removes the lower backplane cover.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-A3 Open and Remove the Front Door, page 1-12
Required
Onsite
None
NTP-A4 Remove the Backplane Covers
1-15.
1-16. If not, continue with the
Cisco ONS 15454 Procedure Guide, R4.0
1-16.
"NTP-A5 Install the
"NTP-A6 Install the
1-15