Cisco ONS 15454 Procedure Manual page 16

NTP-A5 Install the Electrical Interface Assemblies
DLP-A11 Remove the Backplane Sheet Metal Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
To remove the lower clear plastic backplane cover, loosen the five screws that secure it to the ONS 15454
Step 1
and pull it away from the shelf assembly.
Loosen the nine perimeter screws that hold the backplane sheet metal cover(s) in place.
Step 2
Lift the panel by the bottom to remove it from the shelf assembly.
Step 3
Store the panel for later use. Attach the backplane cover(s) whenever EIA(s) are not installed.
Step 4
Return to your originating procedure (NTP).
Step 5
NTP-A5 Install the Electrical Interface Assemblies
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 Procedure Guide, R4.0
1-16
This task removes the backplane sheet cover that is installed on the
backplane when EIAs are not installed.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
NTP-A3 Open and Remove the Front Door, page
DLP-A10 Remove the Lower Backplane Cover, page 1-15
Required
Onsite
None
This procedure describes how to install electrical interface assemblies
(EIAs). Typically, an EIA panel is already installed on the backplane when
the node is received, but EIA panels can be ordered separately. Refer to the
Cisco ONS 15454 Reference Manual for descriptions of the EIAs.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
perimeter screws (9)
inner screws (12)
backplane cover screws (5)
EIA card (SMB, BNC, AMP Champ)
NTP-A4 Remove the Backplane Covers, page 1-15
Required if the node will use electrical signals
Onsite
None
Chapter 1 Install the Shelf and Backplane Cable
1-12,
March 2003