Download Print this page

Cisco ONS 15454 Procedure Manual page 38

Hide thumbs Also See for ONS 15454:

Advertisement

NTP-A8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections
DLP-A21 Install LAN Wires on the Backplane
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Rather than using the LAN wires, you can use the LAN connection port on the TCC+/TCC2 if preferred.
Note
Use either the backplane connection or the TCC+/TCC2 front connection. You cannot use the LAN
backplane pins and the LAN connection port on the TCC+/TCC2 simultaneously; however, it is possible
for you to make a direct connection from a computer to the LAN connection port on the TCC+/TCC2
while the LAN backplane pins are in use as long as the computer that is connected directly to the
TCC+/TCC2 is not connected to a LAN.
Step 1
Using #22 or #24 AWG (0.51 mm² or 0.64 mm²) wire or CAT5 UTP Ethernet cable, wrap the wires on
the appropriate wire-wrap pins according to local site practice.
Caution
A frame ground pin is located beneath each pin field (FG2 for the LAN pin field). Wrap the ground shield
of the LAN interface cable to the frame ground pin.
Table 1-3
Pin Field
LAN 1
Connecting to data
circuit-terminating
equipment (DCE*) (a hub
or switch); the ONS 15454
is a DCE
LAN 1
Connecting to data terminal
equipment (DTE) (a
PC/workstation or router)
Cisco ONS 15454 Procedure Guide, R4.0
1-38
This task installs the LAN wires on the backplane.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) wire, preferably CAT5 UTP
NTP-A4 Remove the Backplane Covers, page 1-15
Required if the node is using an external LAN connection
Onsite
None
Cross talk may result if both receive (Rx) and transmit (Tx) pins connect on the same twisted
pair of wires from the CAT5 cable. The two Tx pins need to be on one twisted pair, and the
two Rx pins need to be on another twisted pair.
LAN Pin Assignments
Backplane Pins
B2
A2
B1
A1
B1
A1
B2
A2
Chapter 1
Install the Shelf and Backplane Cable
Table 1-3
shows the LAN pin assignments.
RJ-45 Pins
Function/Color
1
TX+ white/green
2
TX- green
3
RX+ white/orange
6
RX- orange
1
RX+ white/green
2
RX- green
3
TX+ white/orange
6
TX- orange
March 2003

Advertisement

loading