Cisco ONS 15454 Procedure Manual page 40

NTP-A120 Install an External Wire-Wrap Panel to the AEP
Table 1-4
Pin Field
Craft
Step 3 Return to your originating procedure (NTP).
NTP-A120 Install an External Wire-Wrap Panel to the AEP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Position the lower cover over the AEP. Make sure that the AEP AMP Champ connectors protrude
Step 1
through the cutouts in the lower cover
Cisco ONS 15454 Procedure Guide, R4.0
1-40
Craft Interface Pin Assignments
Contact
A1
A2
A3
A4
This procedure connects an external wire-wrap panel to the AEP to provide
the physical alarm contacts for the AEP.
External wire-wrap panel
NTP-A119 Install the Alarm Expansion Panel, page 1-31
Required if you installed an AEP
Onsite
None
Chapter 1
Function
Receive
Transmit
Ground
DTR
(Figure 1-17).
Install the Shelf and Backplane Cable
March 2003