Cisco ONS 15454 Procedure Manual page 34

NTP-A8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections
Table 1-1
Wire
Tip 6
Tip 7
Tip 8
Tip 9
Tip 10
Tip 11
Step 6 Attach the connector on the opposite end of the cable assembly to the EIA/TIA-485 connector port on
the AEP
Continue with the
Step 7
procedure on page
Stop. You have completed this procedure.
NTP-A8 Install Wires to Alarm, Timing, LAN, and Craft Pin
Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
AIC or AIC-I card and not using an AEP.
Complete the
Step 2
wires are necessary to provision external timing.
Step 3 Complete the
(or the LAN port on the TCC+/TCC2) are necessary to create an external LAN connection.
Step 4 Complete the
the EIA/TIA-232 port on the TCC+/TCC2) are required to access TL1 using the craft interface.
Caution
Cisco ONS 15454 Procedure Guide, R4.0
1-34
Pin Assignments for the AEP (continued)
Pin AEP Signal
6 AE_CLK_P
5 AE_CLK_N
4 AE_DOUT_P
3 AE_DOUT_N
2 AE_DIN_P
1 AE_DIN_N
(Figure 1-13 on page 1-33).
"NTP-A8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections"
1-34.
This procedure describes how to install alarm, timing, LAN, and craft
wires.
Wire wrapper
#22 or #24 AWG (0.51 mm² or 0.64 mm²) alarm wires
NTP-A4 Remove the Backplane Covers, page 1-15
As needed
Onsite
None
"DLP-A19 Install Alarm Wires on the Backplane" task on page 1-35
"DLP-A20 Install Timing Wires on the Backplane" task on page 1-37
"DLP-A21 Install LAN Wires on the Backplane" task on page 1-38
"DLP-A22 Install the TL1 Craft Interface" task on page 1-39
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the
wristband cable into the ESD jack located on the lower-right outside edge of the shelf
assembly.
Chapter 1 Install the Shelf and Backplane Cable
AIC-I Signal
AE_CLK_P
AE_CLK_N
AE_DIN_P
AE_DIN_N
AE_DOUT_P
AE_DOUT_N
if you are using an
as needed. Timing
as needed. LAN wires
as needed. Craft wires (or
March 2003