Cisco ONS 15454 Procedure Manual page 21

Chapter 1 Install the Shelf and Backplane Cable
DLP-A14 Install the AMP Champ EIA
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Align the AMP Champ panel with the backplane and insert and tighten the nine perimeter screws
(P/N 48-0358) at 8 to 10 lb. (3.6 to 4.5 kg).
Align an AMP Champ card with the backplane connector and push until it fits snugly. Repeat until you
Step 2
have installed all six AMP Champ cards.
To secure each AMP Champ card to the cover panel, insert and tighten a screw (P/N 48-0003) at the top
Step 3
of each card at 8 to 10 lb. (3.6 to 4.5 kg).
Place the AMP Champ fastening plate along the bottom of the cover panel, and hand-tighten the two
Step 4
thumbscrews.
Figure 1-8
March 2003
This task installs an AMP Champ EIA.
#2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
9 perimeter screws
12 inner screws
5 backplane cover screws
6 AMP Champ cards
EIA panel
NTP-A4 Remove the Backplane Covers, page 1-15
Required if you are using DS1-14 cards and prefer an AMP interface to an
SMB interface
Onsite
None
shows an AMP Champ EIA installation.
NTP-A5 Install the Electrical Interface Assemblies
Cisco ONS 15454 Procedure Guide, R4.0
1-21