Cisco ONS 15454 Procedure Manual page 45

Chapter 1 Install the Shelf and Backplane Cable
NTP-A9 Install the Electrical Card Cables on the Backplane
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
Caution
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Refer to the Cisco ONS 15454 Reference Manual for more information about EIAs.
Note
Complete the
Step 1
page 1-46
To install DS-1 cables using AMP Champ cables, complete the
Step 2
Cables on the AMP Champ EIA" task on page
Complete the
Step 3
Complete the
Step 4
as needed.
Complete the
Step 5
Continue with the
Step 6
Stop. You have completed this procedure.
March 2003
Optional EIA backplane covers are typically pre-installed when ordered
with the ONS 15454. The following procedure describes how to install the
electrical card cables to the backplane. If the shelf was not shipped with the
correct EIA interface, you must order and install the correct EIA.
Wire wrapper
Twisted-pair cables
BNC insertion tool
SMB cable connector
NTP-A5 Install the Electrical Interface Assemblies, page 1-16
Required if you are using electrical cards
Onsite
None
"DLP-A23 Install DS-1 Cables Using Electrical Interface Adapters (Balun)" task on
as needed. Baluns are used on SMB EIAs to properly terminate DS-1 signals.
"DLP-A25 Install Coaxial Cable With BNC Connectors" task on page 1-50
"DLP-A26 Install Coaxial Cable With High-Density BNC Connectors" task on page 1-51
"DLP-A27 Install Coaxial Cable with SMB Connectors" task on page 1-52
"NTP-A10 Route Electrical Cables" procedure on page
NTP-A9 Install the Electrical Card Cables on the Backplane
"DLP-A24 Install DS-1 AMP Champ
1-47.
Cisco ONS 15454 Procedure Guide, R4.0
as needed.
as needed.
1-53.
1-45