Source Id Setup - Cisco D9887B Installation And Configuration Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Downmix
1 Use the Up and Down buttons to move the cursor to "Ch Downmix," then press
the Enter button.
2 Use the Up and Down buttons to select the desired downmix ("2/0 LR", "2/0
Auto", "2/0 LtRt", "MonoChan1", "MonoChan2"), then press the Enter button to
save the selection.
Note: The "2/0 Auto" is used by Dolby Digital Plus (EAC3) to use "2/0 LR" or
"2/0 LtRt" based on the received audio metadata. If the metadata is not present,
like for Dolby Digital (AC3), "2/0 LtRt" is used.
Dynamic Range
1 Use the Up and Down buttons to move the cursor to "Dyn Range," then press the
Enter button.
2 Use the Up and Down buttons to set the Dynamic Range to "Enabled" or
"Disabled," then press the Enter button to save the selection.

Source ID Setup

There are two modes that the Source ID can be obtained – Auto or Manual. In Auto
mode, the unit attempts to discover the Source ID that is signaled in the stream. The
user specifies a timeout for the length of time the unit searches for the Source ID in
the stream. If not found, the user entered name is used. In Manual mode, the user
entered name is used. To setup the Source ID, use the following steps:
1 Start out at the home screen (where it shows the TS bit rate).
2 Press the Left button.
3 Use the Up and Down buttons to move the cursor to "Source ID," then press the
Enter button.
4 Press the Enter button again to edit the Source ID settings.
128 78-4043743-01 Rev A