Snmp Mib Modules; Snmp Settings - Cisco D9887B Installation And Configuration Manual

Chapter 5 Using the Web Client to Configure the D9887B Receiver

SNMP MIB Modules

In order to control the D9887B receiver using SNMP, the MIB modules need to be
downloaded. The Sencore specific MIB modules are displayed under the "SNMP
MIB Modules" heading. The generic MIB modules can be viewed and downloaded
by clicking on the "View All MIB Modules..." hyperlink. That will bring up a new
window displaying all the generic MIB modules. To download these, right-click on
the desired MIB module under the "SNMP MIB Modules" heading and select "Save
Target As..."

SNMP Settings

The next section is the SNMP settings. This section gives an overview of all the
SNMP settings as well as the configuration of SNMP. To edit the SNMP settings, use
the following steps:
1 Click the Window button under the "SNMP Settings" heading. This will bring up
a new edit form in the middle of the screen.
2 Use the drop-down menus and input boxes to configure SNMP to the desired
settings.
3 At the top of the edit form, there are five drop-down menus for enabling or
disabling five separate SNMP traps as well.
4 When all of the settings have been configured, click the Apply button to save the
settings.
180 78-4043743-01 Rev A