Output Control - Cisco D9887B Installation And Configuration Manual

1 Use the Up and Down buttons to move the cursor to "Reset Counters," then
press the Enter button.
2 Press the Enter button again to reset the counters.

Output Control

To configure this card as an output, use the following steps:
1 Press the Output button.
Note: For Configuration 2 units, select RDS1 or RDS2, then press Enter.
2 Use the Up and Down buttons to move the cursor to the "MPEG/IP" card of the
specific slot (e.g. 1-4). Notice the location diagram in the upper right corner of the
screen changes as the cursor moves by each card.
3 Press the Enter button once to display the selection screen for "Transmit 1" and
"Transmit 2" of the MPEG/IP card.
Transmit 1
1 Use the Up and Down buttons to move the cursor to "Transmit 1," then press the
Enter button. The status will be displayed.
2 Press the Enter button one more time to get to the Edit screen.
3 Use the Up and Down buttons to move the cursor to "Transmit," then press the
Enter button.
4 Use the Up and Down buttons to set the Transmit 1 to "Enabled" or "Disabled,"
then press the Enter button to save the selection.
78-4043743-01 Rev A
Dual MPEG over IP Input/ UDP Output Option
111