Cisco D9887B Installation And Configuration Manual page 142

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Video
1 Use the Up and Down buttons to move the cursor to "Video PID," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to set the PID, then press the Enter button to save the selection.
Audio 1 PID
1 Use the Up and Down buttons to move the cursor to "Aud 1 PID," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to set the PID, then press the Enter button to save the selection.
Audio 2 PID
1 Use the Up and Down buttons to move the cursor to "Aud 2 PID," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to set the PID, then press the Enter button to save the selection.
Audio 3 PID
Note: This menu is only available if the unit is equipped with a second decoder in
Configuration 1.
1 Use the Up and Down buttons to move the cursor to "Aud 3 PID," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to set the PID, then press the Enter button to save the selection.
118 78-4043743-01 Rev A