Input B - Cisco D9887B Installation And Configuration Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Symbol Rate A
1 Use the Up and Down buttons to move the cursor to "SymRt," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit, and use the Up and
Down buttons to change the symbol rate (0.256 – 30 MSps).
3 Press the Enter button to save the selection.

Input B

These settings correspond to the input on "Source B."
Modulation Type B
1 Use the Up and Down buttons to move the cursor to "Mod," then press the Enter
button.
2 Use the Up and Down buttons to select Modulation type, then press the Enter
button to save the selection.
Note: The following Modulation types are settable:
DVB-QPSK
DVB-QPSK 1/2
DVB-QPSK 2/3
DVB-QPSK 3/4
DVB-QPSK 5/6
DVB-QPSK 7/8
Frequency B
The ASM card tunes by the L-band frequency rather than the transponder frequency
or local oscillator value. The L-band frequency (950 – 2150 MHz) is the difference
between the downlink transponder frequency and the LNB local oscillator
frequency.
70
Adv QPSK
Adv QPSK 1/2
Adv QPSK 2/3
Adv QPSK 3/4
Adv QPSK 5/6
Adv QPSK 7/8
8-PSK
8-PSK 2/3
8-PSK 3/4 (2.05)
8-PSK 3/4 (2.10)
8-PSK 3/4 (2.20)
8-PSK 5/6
8-PSK 8/9
78-4043743-01 Rev A