Reset Unit - Cisco D9887B Installation And Configuration Manual

Reset Unit

If a problem should ever arise where the D9887B receiver has locked up, or
malfunctioned in some manner, it is possible to perform a soft reset from the web
client. A soft reset will reboot the D9887B receiver and hopefully take care of any
previous problems the unit was exhibiting. A soft reset will not change any setting.
To perform a soft reset, use the following steps:
1 Click the "Reset Unit" hyperlink under the "Reset Unit" heading.
2 A new dialog box will appear asking "Are you sure that you want to reset the
unit?." Click the Yes button to reset the unit.
Caution: Resetting the unit is a service affecting event and service will be
interrupted while the unit is rebooting.
3 A progress bar will appear on the screen as the unit is resetting. It may take up to
5 minutes for the D9887B receiver to restart depending on the configuration.
4 Once the unit has restarted, the web client will be redirected back to the login
page for the D9887B receiver.
78-4043743-01 Rev A

Reset Unit

191