Power Connection; Ac Power Connection - Cisco D9887B Installation And Configuration Manual

4 Secure the D9887B receiver to the rack by installing the four supplied screws
through the front mounting holes and tightening.

Power Connection

Using the proper power connections is vital to the safe operation of the D9887B
receiver. Only use the supplied 3-prong power connector or one with equal
specifications.
WARNING:
NEVER tamper with or remove the third prong grounding pin. This could cause
damage to the D9887B receiver, personnel, or property.

AC Power Connection

The D9887B receiver is intended for use on either 120V or 240V systems. The power
supply will automatically detect the system it is connected to. To hook up the power,
use the following steps:
1 Locate the AC power cord included with the D9887B receiver.
2 Plug the female end of the power cord (end with no prongs) into the back of the
unit.
3 Locate a protected outlet (usually inside of the rack) to plug the male end of the
power cable into.
78-4043743-01 Rev A
Installation
3