Hd/Sd Genlock Offset; Vertical - Cisco D9887B Installation And Configuration Manual

3 Then use the Up and Down buttons to toggle between "Enabled" and "Disabled,"
then press the Enter button to save changes.

HD/SD Genlock Offset

The Video Output (2 HD/SD-SDI, 1 RGBHV/YPvPr/Comp) option card can be
Genlocked to a standard "black and burst" or Tri-level sync signal applied to the
Genlock input on the back panel. The frame rate of the "black and burst" signal must
be the same as the frame rate of the video output. The "Genlock Reference," under
the Menu button, must be set to the type of Genlock signal being used as well. If the
Genlock input source is lost, the red Error LED will illuminate, a Decoder Error will
show, and the Error list will show the error. The video will restore but will not be
Genlocked until the Genlock signal is restored.
1 Use the Up and Down buttons to move the cursor to "HD Genlock Offset" or "SD
Genlock Offset," then press the Enter button.
Note: Both HD and SD Genlock are setup using the same steps.

Vertical

1 Use the Up and Down buttons to move the cursor to "Vert," then press the Enter
button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the number of lines, then press the Enter button to save
the selection.
Note: The maximum amount of offset is determined by the format of the video
set.
78-4043743-01 Rev A
Video Output (2 HD/SD-SDI, 1 RGBHV/YPbPr/Comp) Option
79