Cisco D9887B Installation And Configuration Manual page 160

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Note: Then use the steps above to setup Priority 2.
No PSI Mode
This mode should only be used if both the PID information and audio/video
formats are known about the stream.
PCR PID
Note: This menu is only available if the "Tune Mode" is set to "No PSI."
1 Use the Up and Down buttons to move the cursor to "PCR PID," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit, then use the Up and
Down buttons to set the desired PCR PID, then press the Enter button to save the
PID.
Video PID
1 Use the Up and Down buttons to move the cursor to "Video PID," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit, then use the Up and
Down buttons to set the desired Video PID, then press the Enter button to save
the PID.
Video Type
The only video type that is supported by the MPEG-2 Decoder 4:2:2 with Genlock (1
Video, 4 Audio) decoder is MPEG 2. This value is set and cannot be changed.
Audio 1 PID
1 Use the Up and Down buttons to move the cursor to "Aud 1 PID," then press the
Enter button.
136 78-4043743-01 Rev A