Cisco D9887B Installation And Configuration Manual page 118

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Use Selected PIDs
The "Use Selected PIDs" operation mode allows the selection of individual video and
audio PIDs to send to the CAM for decryption. There is no restriction on which PIDs
can be selected (audio and video PIDs need not be in the same program). The PIDs
are selected from the PIDs that are available in the PMT of the input. If there is no
input PMT available, the selection of PIDs will not be possible. If a selected PID is no
longer listed in the input PMT, the Service that contained the PID will be listed
followed by a "*" indication. The Services with PIDs that are no longer in the PMT
can be found on the bottom of the Service list.
Once "CAM Operation Mode" has been set to "Use Selected PIDs," use the following
steps to configure your D9887B receiver to decrypt selected PIDs.
Note: It is only possible to decrypt more than one program at a time, if the CAM
module supports multiple program decrypting.
1 The Services that are sent to the CAMs are listed under the "CAM1" or "CAM2"
(with the CAM name if available).
2 Use the Up and Down buttons to move the cursor to the program (Service)
which contains the PIDs to be selected, then press the Enter button.
3 The video and audio PIDs that are available for that Service in the PMT are
listed.
4 Use the Up and Down buttons to move the cursor to the PID to be selected or
deselected, then press the Enter button.
5 Press the Enter button to edit the selection.
6 Use the Up and Down buttons to change the selection status.
7 Press the Enter button to save the selection.
Note: The short name is listed (if available) with the Service. The PIDs video type
and audio language information is shown along with the PID.
94 78-4043743-01 Rev A