Cisco D9887B Installation And Configuration Manual page 99

Note: When set to "SD," the NTSC formatted output will be used when the
output video frame rate is 29.95 or 59.94. The PAL formatted output will be used
when the frame rate is 25 or 50. Other frame rates will not produce an SD SDI
output.
SDI Output Squelch
The SDI clock is used to disable the output when a video decoding error is
encountered. When the SDI clock is set to "Squelch," there is no SDI output signal
during the decoding failure. When the SDI clock is set to "Pass," the Raster color is
output during decoding failure.
1 Use the Up and Down button to move the cursor to "SDI Clk," then press the
Enter button.
2 Use the Up and Down buttons to select the desired SDI Clk ("Pass" or "Squelch"),
then press the Enter button to save the selection.
Analog Output Format
Note: If this setting is set incorrectly when using an RGB monitor, the image will
appear green. If this setting is set incorrectly when using a Component monitor,
there will be no video on the monitor.
1 Use the Up and Down buttons to move the cursor to "Anlg Out," then press the
Enter button.
2 Use the Up and Down buttons to select the desired output format ('RGBHV" or
"YPbPr"), then press the Enter button to save the selection.
3 Use the Up and Down buttons to move the cursor to "NTSC Ped," then press the
Enter button.
4 Use the Up and Down buttons to select "Enabled" or "Disabled," then press the
Enter button to save the selection.
78-4043743-01 Rev A
Video Output (2 HD/SD-SDI, 1 RGBHV/YPbPr/Comp) Option
75