Mpeg-2/Mpeg-4 4:2:0 Decoder (1 Video, 2 Audio) Option; General Information; Decoder Setup - Cisco D9887B Installation And Configuration Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
MPEG-2/MPEG-4 4:2:0 Decoder (1 Video, 2 Audio)
Option

General Information

Install Location: Not Field Upgradeable
I/O: The input and output is done through the various other I/O cards. (e.g.
8VSB/QAM Receiver option)
Supported Formats: MPEG-2, MPEG-4, and all formats supported by the option
cards.
Description: The D9887B receiver can be configured as a Single RDS or as a Dual
RDS. As a Single RDS, the D9887B receiver has only one MPEG Decoder. As a Dual
RDS, the D9887B receiver has two MPEG Decoders. The D9887B receiver can be
configured, when ordering, to act as two separate RDSs or as one RDS with two
decoders to enable four audio processors.

Decoder Setup

To setup the D9887B receiver to be able to decode the incoming audio and video, use
the following steps.
1 Press the Home button to bring the display back to the RDS status screen.
2 Press the Left button to access the RDS 1 Decoder Menu.
Note: For Configuration 2 units, all of the following instructions apply exactly
the same except, use the Right button to access the RDS 2 Decoder Menu.
3 Use the Up and Down buttons to move the cursor to "Service Setup," then press
the Enter button.
4 Press the Enter button again to display the Edit screen for the RDS 1 Decoder.
116 78-4043743-01 Rev A