To Edit The Option Card Input Settings; Group Selection Settings - Cisco D9887B Installation And Configuration Manual

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver

To Edit the Option Card Input Settings

To edit this input card, use the following steps:
1 Press the Input button.
Note: For Configuration 2 units, select RDS1 or RDS2, then press Enter.
2 Use the Up and Down buttons to select "Input Modules," and press the Enter
button.
3 Use the Up and Down buttons to move the cursor to the "MPEG/IP" card of the
specific slot (e.g. 1-4). Notice the location diagram in the upper right corner of the
screen changes as the cursor moves by each card.
4 Press the Enter button once to display the Status screen for the MPEG/IP card.
5 Press the Enter button again to display the Edit screen for the MPEG/IP card.

Group Selection Settings

This section allows the user to specify which Receive Group is active (Receive 1 or
Receive 2), if one of the receive groups acts as a backup for the other receive group
(setting the "Active Group" to "Auto") and then setting the backup options.
The backup options assign a primary receive group, what is used to trigger the
switchover to the backup receive group, when the Primary should be restored and
the timeout before switching to the Backup or restoring to the Primary.
The D9887B receiver is usually configured to have either the MPEG/IP backup
enabled or the Input Option backup enabled, not both.
Selecting the Active Receive Group
1 Use the Up and Down buttons to move the cursor to "Active Group," then press
the Enter button.
2 Use the Up and Down buttons to select "1", "2", or "Auto," then press the Enter
button to save the selection.
100 78-4043743-01 Rev A