Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
3
Use the Up and Down buttons to move the cursor to the "DVB-S/S2" card of the
specific slot (e.g. 1-4). Notice the location diagram in the upper right corner of the
screen changes as the cursor moves by each card.
4
Press the Enter button once to display the Status screen for the DVB-S/S2 card.
5
Press the Enter button again to display the Edit screen for the DVB-S/S2 card.
Source
This option will select which input, on the back of the card, will be active.
1
Use the Up and Down buttons to move the cursor to "Source Select," then press
the Enter button.
2
Use the Up and Down buttons to select which input to be active ("A", "B", "C",
"D"), then press the Enter button to save the selection.
Source Settings
These settings correspond to the "Source" input that is selected. Repeat these steps
for each input source, "Source A", "Source B", "Source C", and "Source D."
The DVB-S/S2 card can receive either DVB-S or DVB-S2 transmission.
Use the Up and Down buttons to move the cursor to the Source ("Source A", "Source
B", "Source C", "Source D") to edit the settings, then press the Enter button.
86
78-4043743-01 Rev A