Cisco D9887B Installation And Configuration Manual page 144

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
Service
1 Use the Up and Down buttons to move the cursor to "Service," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to select the program, then press the Enter button to save the
selection.
Audio 1 Index
1 Use the Up and Down buttons to move the cursor to "Aud1 Index," then press
the Enter button.
2 Use the Up and Down buttons to set the desired audio index (0 – 65535), then
press the Enter button to save the selection.
Audio 2 Index
1 Use the Up and Down buttons to move the cursor to "Audio 2 Index," then press
the Enter button.
2 Use the Up and Down buttons to set the desired audio index (0 – 65535), then
press the Enter button to save the selection.
Note: Use the previous steps to setup the Priority 2 as well.
Audio 3 Index
Note: This menu is only available if the unit is equipped with a second decoder in
Configuration 1.
1 Use the Up and Down buttons to move the cursor to "Aud3 Index," then press
the Enter button.
120 78-4043743-01 Rev A