Error Or Event List; General - Cisco D9887B Installation And Configuration Manual

Appendix A
Error/Event List

Error or Event List

General

Bitrate Error - The TS bitrate is not within 100 bps of 19.392 Mbps while using

the 310M card, or it is greater than 160 Mbps while using ASI.
Tuner Lock Error – The FEC is not synchronized. Data on carrier is not

synchronized.
Video Unsupported Profile/Level - The video is not of a supported

profile/level.
Carrier Lock Error - Cannot detect the carrier signal.

TS Rate Invalid - A burst of packets caused the receive FIFO to overflow.

Not Receiving Packets - The card is not receiving IP packets within 1 FEC period

(1 second).
No TS Present Error - There is no sync byte (0x47) found in a 1 second period.

Transport Packet Error - There was an error in the transport stream.

Lock Error - A carrier cannot be found.

Low MER - The MER is lower than the threshold set by the user.

Low Level - The signal level is lower than the threshold set by the user.

System Time Event – If the unit is powered on/off, the time is manually

updated, or the time server is invalid, this event will be triggered.
CA Service Not Found - The CAM is configured to use selected PIDs, but the

selected PID is no longer available in the PMT.
Program Not Found – The Program / Service that is selected is not available.

Band Frequency Error – The Satellite Receiver tuning using Frequency and

Offset is not within the Receiver's tuning range.
FP Login Error Event – There was an attempt to unlock that front panel using

the wrong password.
All SDI Jacks Squelched Error – The Manual Format does not match the SDI

Output Format for both Output A and Output B.
Uncorrectable FEC Error Event – There was an FEC error that was

uncorrectable.
Corrected FEC Error Event – There was an FEC error that was corrected.

202 78-4043743-01 Rev A