Cisco D9887B Installation And Configuration Manual page 128

Chapter 4 Using the Front Panel to Configure the D9887B HDTV Modular Receiver
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the port (0 – 65536), then press the Enter button to save
the selection.
Forward Error Correction
This setting lets the decoder know if it should be expecting FEC data with the active
receive group. If no FEC data is expected, this setting can be disabled to allow
multicasts closer together on the same IP.
1 Use the Up and Down buttons to move the cursor to "FEC," then press the Enter
button.
2 Use the Up and Down buttons to select "Enable" or "Disable," then press the
Enter button to save the selection.
Synchronized Source Setup
1 Use the Up and Down buttons to move the cursor to "SSRC," then press the
Enter button.
2 Use the Up and Down buttons to select "Enable" or "Disable," then press the
Enter button to save the selection.
Synchronized Source Setup Filter
1 Use the Up and Down buttons to move the cursor to "SSRC Filt," then press the
Enter button.
2 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the SSRC Filter, then press the Enter button to save the
selection.
104 78-4043743-01 Rev A